D-Link xStack Reference Manual page 528

xStack
debug ospf clear counter
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To clear all OSPF statistic counters:
DGS-3627:admin# debug ospf clear counter
Command: debug ospf clear counter
Success.
DGS-3627:admin#
debug ospf show request_list
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current OSPF request list:
DGS-3627:admin# debug ospf show request_list
Command: debug ospf show request_list
OSPF Request List:
*Area 0.0.0.0:
Circuit: 1.1.1.1
Neighbor: 90.2.0.1
LSID: 192.194.134.0
LSID: 192.194.135.0
LSID: 192.194.136.0
LSID: 192.194.137.0
LSID: 192.194.138.0
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to reset OSPF statistic counters.
debug ospf clear counter {packet | neighbor | spf}
This command is used to reset OSPF statistic counters.
packet - To reset the OSPF packet counter.
neighbor - To reset the OSPF neighbor event counter.
spf - To reset the OSPF SPF event counter.
If the parameter is not specified, all OSPF counters will be cleared.
Only Administrator level users can issue this command.
Used to display the current internal OSPF request list. This command can be used if one or
more OSPF neighbors remain in "Loading" state.
debug ospf show request_list
This command is used to display the current internal OSPF request list.
None.
Only Administrator level users can issue this command.
IP: 1.1.1.2
RTID: 90.2.0.1
RTID: 90.2.0.1
RTID: 90.2.0.1
RTID: 90.2.0.1
RTID: 90.2.0.1
524