Vlan Trunking Commands - D-Link xStack Reference Manual

xStack
The VLAN Trunking commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
enable vlan_trunk
disable vlan_trunk
config vlan_trunk
show vlan_trunk
Each command is listed, in detail, in the following sections.
enable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the VLAN Trunk:
DGS-3627:admin# enable vlan_trunk
Command: enable vlan_trunk
Success.
DGS-3627:admin#
disable vlan_trunk
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the VLAN Trunk:
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
ports [<portlist> | all] | state [enable | disable]
Used to enable the VLAN trunk function.
enable vlan_trunk
When the VLAN trunk function is enabled, the VLAN trunk ports shall be able to forward all
tagged frames with any VID.
None.
Only Administrator can issue this command.
Used to disable the VLAN trunk function.
disable vlan_trunk
This command disables the VLAN trunk function.
None.
Only Administrator can issue this command.

VLAN TRUNKING COMMANDS

725
103