Message-Digest Algorithm 5 (Md5) Commands - D-Link xStack Reference Manual

xStack

MESSAGE-DIGEST ALGORITHM 5 (MD5) COMMANDS

The Message-Digest algorithm 5 (MD5) configuration commands in the Command Line Interface (CLI) are listed (along
with the appropriate parameters) in the following table.
Command
create md5 key
config md5 key
delete md5 key
show md5
Each command is listed, in detail, in the following sections.
create md5 key
Purpose
Syntax
Description
Parameters
Restrictions
Usage example
To create an entry in the MD5 key table:
DGS-3627:admin# create md5 key 1 dlink
Command: create md5 key 1 dlink
Success.
DGS-3627:admin#
config md5 key
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<key_id 1-255> <password 16>
<key_id 1-255> <password 16>
<key_id 1-255>
{key <key_id 1-255>}
Used to create a new entry in the MD5 key table.
create md5 key <key_id 1-255> <password 16>
This command is used to create an entry for the MD5 key table.
<key_id 1-255> − The MD5 key ID. The user may enter a key ranging from 1 to 255.
<password> − An MD5 password of up to 16 bytes.
Only Administrator and Operator-level users can issue this command.
Used to enter configure the password for an MD5 key.
config md5 key <key_id 1-255> <password 16>
This command is used to configure an MD5 key and password.
<key_id 1-255> − The previously defined MD5 key ID.
<password 16> − The user may change the MD5 password for the md5 key. A new
password of up to 16 characters can be created.
Only Administrator and Operator-level users can issue this command.
452
59