Time And Sntp Commands; Config Sntp - D-Link DGS-1100-16/ME Reference Manual

The Time and SNTP commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config sntp

show sntp
enable sntp
disable sntp
config time
config time_zone
config dst
show time
Each command is listed in detail, as follows:
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
DGS-1100/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
{ipaddress<ipaddr> | poll_interval <sec 30-99999>}(1)
<date ddmthyyyy> <time hh:mm:ss>
operator [+ | -] hour <hour 0-13> minute <minute 0-59>
[disable | annual s_date <start_date 1-31> s_mth <start_mth 1-12> s_time
<start_time hh:mm> e_date <end_date 1-31> e_mth <end_mth 1-12> e_time
<end_time hh:mm> offset [30 | 60 | 90 | 120]]
To setup SNTP service.
config sntp {ipaddress<ipaddr> | poll_interval <sec 30-
99999>}(1)
The config sntp command configures SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
ipaddress <ipaddr> – Specifies the IPv4 address of the SNTP
server.
poll_interval <sec 30-99999> – The interval between requests for
updated SNTP information. The polling interval ranges from 30
seconds to 99999 seconds.
Only administrator-level users can issue this command.

TIME AND SNTP COMMANDS

114
20