Dhcpv6 Server Commands - D-Link xStack Reference Manual

xStack
The DHCPv6 Server commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command
create dhcpv6 pool
delete dhcpv6 pool
show dhcpv6 pool
config dhcpv6 pool ipv6network_addr
config dhcpv6 pool domain_name
config dhcpv6 pool dns_server
config dhcpv6 pool lifetime
config dhcpv6 pool manual_binding
show dhcpv6 manual_binding
show dhcpv6 binding
clear dhcpv6 binding
enable dhcpv6_server
disable dhcpv6_server
show dhcpv6_server
config dhcpv6 pool excluded_address
show dhcpv6 excluded_address
config dhcpv6_server ipif
debug dhcpv6_server state
debug dhcpv6_server packet
Each command is listed, in detail, in the following sections.
create dhcpv6 pool
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Parameters
<pool_name 12>
[<pool_name 12> | all]
{<pool_name 12>}
<pool_name 12> begin < ipv6networkaddr> end <ipv6networkaddr>
<pool_name 12> <domain_name 255>
<pool_name 12> <ipv6addr> {<ipv6addr>}
<pool_name 12> preferred_lifetime <sec 60-4294967295> valid_lifetime <sec
60-4294967295>
<pool_name 12> [add <ipv6addr > client_duid <string 28> | delete [<ipv6addr > |
all] ]
{<pool_name 12>}
{<pool_name 12>}
{<pool_name 12>}
<pool_name 12> [ add begin < ipv6addr> end < ipv6addr > | delete [ begin <
ipv6addr> end < ipv6addr> | all]]
{<pool_name 12>}
<ipif_name 12> state [enable | disable]
[enable | disable]
{all | receiving | sending} state [enable | disable]
This command is used to create a DHCPv6 pool.
create dhcpv6 pool <pool_name 12>
This command is used to create a DHCPv6 pool for the DHCPv6 server.
<pool_name 12> - Enter a name of up to 12 alphanumeric characters to identify the pool to
be created with this command.
Only Administrator and Operator-level users can issue this command.

DHCPV6 SERVER COMMANDS

229
29