xStack
DGS-3627:admin#
debug dhcpv6_relay packet sending state enable
Command: debug dhcpv6_relay packet sending state enable
Success.
DGS-3627:admin#
debug dhcpv6_relay hop_count state
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable debug information flag about the hop count:
DGS-3627:admin#
debug dhcpv6_relay hop_count state enalbe
Command: debug dhcpv6_relay hop_count state enalbe
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
This command is used to enable or disable debug information flag about the hop count.
debug dhcpv6_relay hop_count state [enable | disable]
This command is used to enable or disable debug information flag about the hop count.
hop_count - The hop count is the number of relay agents that have to be relayed in this
message. The range is 1 to 32. The default value is 4.
enable - Enable the hop_count state.
disable - Disable the hop_count state.
Only Administrator and Operator-level users can issue this command.
228