Flash File System (Ffs) Commands - D-Link xStack Reference Manual

xStack
The Flash File System (FFS) commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
show storage_media_info
cd
dir
rename
erase
copy
Each command is listed, in detail, in the following sections.
show storage_media_info
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the storage media's information:
DGS-3627:admin#show storage_media_info
Command: show storage_media_info
------------------------------------------------------
Unit ID is 1
Drive Media_Type
C: Flash
------------------------------------------------------
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual

FLASH FILE SYSTEM (FFS) COMMANDS

Parameters
{[unit <unitid 1-12> | all]}
{<pathname 64>}
{{unit [<unitid 1-12>|all]} <drive_id>}
{{unit <unit_id 1-12>} <drive_id>} <pathname 64> <filename 64>
{{unit <unit_id 1-12>} <drive_id>} <pathname 64>
{<drive_id>} <pathname 64> {{unit <unit_id 1-12>} <drive_id>} <pathname 64>
This command is used to display the information of the storage media available on the
system.
show storage_media_info {[unit <unitid 1-12> | all]}
This command is used to display the information of the storage media available on the
system. There can be one or multiple media on the system. The information for a media
includes the drive number, the media identification.
unit - (Optional) Specifies a unit ID if in the stacking system. If not specified, it refers to the
master unit.
<unitid 1-12> - Enter the unit ID here. This value must be between 1 and 12.
all - Specifies all units.
Only Administrator and Operator-level users can issue this command.
Size Label
15 MB FLASH-A
FS_Type
FAT16_V2
285
37