Ospf Debug Enhancement Commands - D-Link xStack Reference Manual

xStack
The OSPF Debug Enhancement commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
debug ospf show flag
debug ospf neighbor_state_change
state
debug ospf interface_state_change
debug ospf lsa
debug ospf packet
debug ospf retransmission state
debug ospf spf
debug ospf route state
debug ospf route redistribution state
debug ospf route virtual_link state
debug ospf route state
debug ospf timer state
debug ospf show counter
debug ospf clear counter
debug ospf show request_list
debug ospf show redistribution
debug ospf show summary_list
debug ospf show detail
debug ospf timer state
debug ospf log state
debug ospf show log state
debug ospf state
Each command is listed, in detail, in the following sections.
debug ospf show flag
Purpose
Syntax
Description
Parameters
Restrictions
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual

OSPF DEBUG ENHANCEMENT COMMANDS

Parameters
[enable | disable]
{dr_bdr_selection} state [enable | disable]
{all | originating | installing | receiving | flooding} state [enable | disable]
{all | receiving | sending} state [enable | disable]
[enable | disable]
{all | intra | inter | extern} state [enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
[enable | disable]
{packet | neighbor | spf}
{packet | neighbor | spf}
[rt_link | net_link | summary_link | external_link | type7_link]
[enable | disable]
[enable | disable]
[enable | disable]
Used to display the OSPF debug flag setting.
debug ospf show flag
This command is used to display the OSPF debug flag setting.
None.
Only Administrator level users can issue this command.
517
67