Time And Sntp Commands - D-Link DES-3326S Command Line Interface Reference Manual

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in
the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
config sntp
show sntp
enable sntp
disable sntp
config time
config time-zone
config dst
show time
Each command is listed, in detail, in the following sections.
D-Link DES-3326S Layer 3 Switch CLI Reference
Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval
<int 30-99999>}(1)
<date ddmmmyyyy > <time hh:mm:ss >
{operator(1) [+ | -] | hour(2) <gmt_hour 0-13> | min(3)
<minute 0-59>}
[disable|repeating {s-week<start_week 1-4,last>
| s-wday <start_weekday sun-sat>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-week <end_week 1-4,last>
| e-wday <end_weekday sun-sat>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60|90|120]}
| annual {s-date <start_date 1-31>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-date <end_date 1-31>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60 | 90 | 120]}]}
T SNTP C
IME AND
205
24
OMMANDS