Time And Sntp Commands; Config Sntp - D-Link DGS-1100-06/ME Cli Reference Manual

The Time and SNTP commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command

config sntp

show sntp
enable sntp
disable sntp
config time
config time_zone
operator
config dst
show time
Each command is listed in detail, as follows:
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
DGS-1100-06/ME Metro Ethernet Managed Switch CLI Reference Guide
Parameter
{primary [<ipaddr> | <ipv6addr>] | secondary [<ipaddr> | <ipv6addr>] | poll-
interval <sec 30-99999>}
<date> <systime>
[+ hour <gmt_hour 0-13> minute <minute 0-59> | - hour <gmt_hour 0-12> minute
<minute 0-59>]
[disable | [annual s_date <start_date 1-31> s_mth <start_mth 1-12> s_time
<start_time> end_date <int 1-31> e_mth <end_mth 1-12> e_time <end_time> |
offset [30 | 60 | 90 | 120]]]
To setup SNTP service.
config sntp {primary [<ipaddr> | <ipv6addr>] | secondary
[<ipaddr> | <ipv6addr>] | poll-interval <sec 30-99999>}
The config sntp command configures SNTP service from an SNTP
server. SNTP must be enabled for this command to function (See
enable sntp).
primary [<ipaddr>| <ipv6addr>] – Specifies the IPv4 or IPv6 address
of the primary SNTP server.
secondary [<ipaddr>| <ipv6addr>] – Specifies the IPv4 or IPv6
address of the secondary SNTP server.
poll-interval <sec 30-99999> – The interval between requests for
updated SNTP information. The polling interval ranges from 60
seconds (1 minute) to 86,400 seconds (1 day).
Only administrator or operate-level users can issue this command.
SNTP service must be enabled for this command to function (enable
sntp).

TIME AND SNTP COMMANDS

192
29