D-Link xStack Reference Manual page 406

xStack
show limited multicast address
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the limited multicast address on ports 1 to 2:
DGS-3627:admin# show limited multicast address 1-2
Command: show limited multicast address 1-2
Port : 1
State : Disabled
Access : None
No. Name
---- ----------------
Port : 2
State : Disabled
Access : None
No. Name
---- ------------------------------------
Total Entries: 0
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
Used to show per-port limited IP multicast address range.
show limited multicast address {<portlist>}
The show limited multicast address command allows users to show multicast address
range by ports.
<portlist> − A port or range of ports on which the limited multicast address range to be shown
has been assigned. The beginning and end of the port list range are separated by a dash.
Non-contiguous portlist entries are separated by a comma. (ex: 1-3,7-9)
None. This command is used as a backwards compatible command for legacy devices.
-----------------
From
From
---------------
402
To
-------------
To
---------------