Quick Reference Guide To System Administration - Lucent Technologies MERLIN Plus Release 2 System Manual

Quick Reference Guide to System Administration

Administration Procedure
Specify toll-prefix or area-code-only dialing.
Specify Touch-Tone or rotary (pulse) dialing.
The following table is a quick guide to administration procedures for the
MERLIN Plus Communications System. If you need more information on a
procedure than the table gives you, look up the procedure in Section 5,
"Reference."
Before you perform the steps given for any procedure, you first have to enter
administration mode as follows:
Slide the T/P switch on the left side of the console to P.
1
The red lights next to the line buttons go on steady.
The green lights next to the line buttons begin flashing.
The console rings every 5 seconds to remind you that it's in programming mode.
Touch Administer.
2
The red lights go on steady next to Administer and Restrict.
All other lights go off, and the ringing stops.
If you are performing several of these procedures in one administration
NOTE:
session, you don't have to leave administration mode after each one.
Simply dial the appropriate code or touch the appropriate button to
begin the next procedure.
When you finish administering the system, leave administration mode as
follows:
Slide the T/P switch to the center position.
1
Change any voice terminal (telephone) button labels and any entries on forms
2
or directories to reflect the administration or programming changes you've
made.
1 Enter administration mode.
2 Dial the appropriate code:
*36 for toll-prefix dialing
*37 for area-code-only dialing.
3 Touch Administer.
The console beeps twice.
4
Leave administration mode.
1 Enter administration mode.
2 Dial the appropriate code:
*38 for Touch-Tone dialing
*39 for rotary (pulse) dialing.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode.
Do This
Quick Reference Guide to System Administration
(continued)
3-37