Lucent Technologies MERLIN Plus Release 2 System Manual page 70

HOLD DISCONNECT
INTERVAL
VOICE TERMINAL JACK
ASSIGNMENTS
3-14 Basic Administration
If you placed a check mark in the column marked "Short" under "Hold
Disconnect Interval" on the System Configuration Form, then your local
telephone company uses the 50 millisecond disconnect interval instead of the
450 millisecond interval. If your local telephone company uses a short interval,
you must administer this setting for each incoming line in the system.
Follow the procedure below to administer a short hold disconnect interval:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *69.
2
Touch each incoming line button to change the disconnect interval.
3
Green light on = line assigned the long disconnect interval
Green light off = line assigned the short disconnect interval
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5
Your MERLIN Plus system has twenty jacks for voice terminals and special
features. If you are using the ASA features (CF, DXD, RLA, or SA),
Busy Buster (BB), Call Report, or System Feature Report (Reports), you need to
assign a jack for them. The "Voice Terminal" form indicates the default jack
assignments for these features and the main attendants, if you have changed
these assignments on your form, use the appropriate procedure below to change
the jack assignments accordingly:
You cannot reassign any of the following features to jack 10 since it is
NOTE:
reserved for the main attendant.
Changing the Automatic System Access (ASA) jack assignment:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *59.
2
The green light goes on next to the Auto Intercom button of the jack assigned to ASA.
Perform one of the following procedures:
3
> Touch the Auto Intercom button of the jack you want to assign to ASA.
The green light goes off next to the old Auto Intercom button, and the green light goes on
next to the newly assigned Auto Intercom button.
>
Dial the intercom number of jack you're assigning to ASA.
If you hear a denial tone, the feature is on or the VSP port is
NOTE:
active. You can either wait or turn off the feature.
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5