Lucent Technologies MERLIN Plus Release 2 System Manual page 158

Call Forwarding/Remote Line Access Disconnect Timer
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
The Call Forwarding/Remote Line Access Disconnect Timer is used in
conjunction with the Call Forwarding and Remote Line Access features in
MERLIN Plus systems for which the Central Office (CO) lines do not provide a
forward disconnect signal. The timer disconnects calls made using
Call Forwarding and/or Remote Line Access after these calls reach a call
duration threshold that is set for the system. This threshold may be set between
1 and 99 minutes.
The timer will disconnect a Call Forwarding or Remote Line Access call at the
administered interval, even if a conversation is in progress.
This feature should only be used if your CO lines do not provide a forward
disconnect signal (also known as a "held call disconnect signal") of
450 msec or 50 msec.
If your responsibilities do not include system administration, skip this section,
To administer the Customer Administrable Timer:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *68.
2
Dial the desired three-digit timer value. You must dial 3 digits:
3
For example, to set the timer value to 1 minute, you must dial 001, a value of
10 minutes would be dialed 010, and a value of 120 minutes would be
dialed 120.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
T P
Administer
None
None
Administer
68 # 01 - # 99
MERLIN Plus System Features
T P
5-39