Fcc Notification And Repair Information - Lucent Technologies MERLIN Plus Release 2 System Manual

FCC Notification and Repair Information

INTERFERENCE
INFORMATION NOTICE
FCC REGISTRATION AND
REPAIR INFORMATION
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions in this manual, may
cause interference to radio communications. The equipment has been tested and
found to comply with the limits for a Class A computing device pursuant to
Subpart J or Part 15 of FCC Rules, which are designed to provide reasonable
protection against such interference when the equipment is operated in a
commercial environment. Operating this equipment in a residential area is likely
to cause interference, in which case the user, at his or her own expense, will be
required to do whatever is necessary to correct the interference.
This equipment is registered with the FCC in accordance with Part 68 of its
rules. In compliance with the rules, you are to be advised of the following:
Means of Connection: Connection of this equipment to the telephone
1
network must be through a standard network interface jack: USOC RJ11C or
RJ14C, or a multiline network interface cable and connector USOC R121.
Connection to off-premises stations requires a USOC RJ2GX.
This equipment must be ordered from your local telephone company.
This equipment may not be used with party lines or coin telephone lines.
Notification of the Local Telephone Company: Before connecting this
2
equipment, you or your equipment supplier must notify your local telephone
company's business office of the following:
The telephone numbers you will be using with this equipment.
The registration number for the MERLIN
AS593M-13529-KF-E
The ringer equivalent number (REN) for the MERLIN Plus system:
0.8A
You must also notify your local telephone company if and when this
equipment is permanently disconnected from the lines.
Installation and Operational Procedures: The System Manual and the
3
MERLIN Plus Installation Guide contain information about installation and
operational procedures.
Repair Instructions: If you experience trouble because your equipment is
4
malfunctioning, the FCC requires that the equipment not be used and that it
be disconnected from the network until the problem has been corrected.
Repairs to this equipment can only be made by the manufacturers, their
authorized agents, or by others who may be authorized by the FCC.
®
Plus system:
FCC Notification and Repair Information 1-1