Lucent Technologies MERLIN Plus Release 2 System Manual page 313

ADMINISTRATION
PROGRAMMING
HOW TO USE
6-22 Accessory Equipment
You should use the Music-on-Hold feature with DXD so that callers can hear
music when they are placed on hold. See "Direct Extension Dialing" in this
section.
You can also use the Music-on-Hold feature with System Answer, so that callers
hear a special prerecorded message or music while they are waiting.
If your responsibilities do not include system administration, skip this
information.
From the administrator/attendant console, you can set the volume for
Music-on-Hold or turn it off by dialing one of the four settings listed below:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial one of the following codes to set the volume you prefer.
2
> Dial *12 to turn off Music-on-Hold.
> Dial *13 to set the volume to low.
> Dial *14 to set the volume to medium.
> Dial *15 to set the volume to high.
Touch Administer.
3
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
4
If you want to set the volume on the background music for the building or turn
the music off, dial one of the following codes:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial one of the following codes to set the volume you prefer:
2
> Dial *16 to turn off the background music.
> Dial *17 to set the volume to low.
> Dial *18 to set the volume to medium.
> Dial *19 to set the volume to high.
Touch Administer.
3
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
4
None
Operate your audio system according to the directions that came with the
equipment.