System Reset - Lucent Technologies MERLIN Plus Release 2 System Manual

System Reset

DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
5-148 MERLIN Plus System Features
This feature is intended for service personnel only.
WARNING:
When the service person or the administrator uses System Reset, the entire
MERLIN Plus system is set to the initial feature assignments, and consequently
erases any system administration, such as System Speed Dial numbers or call
restrictions. It is useful when making radical changes to the system or starting
administration over again.
When the the service person on the administrator resets the system, all
programming done for any voice terminal in the MERLIN Plus system is erased.
If the administrator has administered customized line assignments for any voice
terminal, these are erased also, and the line configuration is returned to square
operation. All administered features are erased.
System Reset requires readministering your system and reprogramming
all voice terminals.
To reset your system to the initial feature assignments:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *99198.
2
The console beeps twice.
If the console beeps only once or not at all, the reset didn't work,
NOTE:
probably because someone was using the system when you dialed
the System Reset code. Wait until no one is using the system, and
try the reset again.
3 Go to the control unit and turn off the power for ten seconds,
then turn it back on.
The red lights go on, and the green lights flash.
The console rings every 5 seconds.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
T P
Administer
ON
Administer
OFF
99198
T P