Lucent Technologies MERLIN Plus Release 2 System Manual page 103

Administration Procedure
Reset the system.
Select a message to be played with System
Answer.
Select number of rings before a call is picked
up by an ASA feature.
Assign a template to a voice terminal.
This procedure erases all system administration and telephone
WARNING:
programming, returns the system to its factory settings, and restores
initial feature assignments to the phones. Use this feature only
when you want to change the system radically.
1 Enter administration mode.
2 Dial *99198.
The console beeps twice.
3 Turn the power off, wait 10 seconds, and then turn it on again.
4 Leave administration mode.
1 Enter administration mode.
2 Dial *77 followed by the desired option:
0 = no voice message
1 = "Please hold"
2 = "Please hold, your call will be handled momentarily"
If a line number is administered using *50, the following message is
NOTE:
appended to the end of message 1 and 2: "You have reached . . ."
where . . . is a number entered by the system administrator
for Call Forwarding.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode.
1 Slide the T/P switch to P and touch Administer.
2 Dial *76 plus the ASA feature number:
1 = DXD
2 = CF
3 = RLA
4 = SA
3
Dial the number of rings (between 0 and 9) before the ASA feature picks up
the call.
If the number of rings is set to 0, the voice terminal will not ring.
NOTE:
and the calls will be immediately answered.
4 Touch Administer.
The console beeps twice.
5 Leave administration mode by sliding the T/P switch to the center position.
1 Enter administration mode.
2 Dial* 10 followed by the desired template:
1 = Clear template
2 = Dialer template
3 = Feature template
4 = Receptionist/Secretary template
3 Touch the Auto Intercom button or dial the intercom number for the voice
terminal being assigned the template.
4 Touch Administer.
The console beeps twice.
5 Leave administration mode.
Quick Reference Guide to System Administration
Do This
3-47