Lucent Technologies MERLIN Plus Release 2 System Manual page 157

PROGRAMMING
HOW TO USE
5-38 MERLIN Plus System Features
Dial the new CF telephone number plus a pound (#).
5
The VSP repeats the new number and asks you to either confirm it by dialing a * or deny it by
dialing 00.
Dial * to confirm, or dial 00 to return to step 5, above, and try again.
6
After receiving the confirmation signal, the VSP repeats the new number once more and
identifies it as the new call forward number
Hang up.
7
555-1234
A button with a red light next to it is required for the CF feature.
To program a CF/DXD button on a voice terminal:
Label the button CF/DXD.
1
Slide the T/P switch to P.
2
The voice terminal rings every 5 seconds to remind you that you're programming and that you
can't place or receive calls.
Touch the button you want to program.
3
Dial *83.
4
Slide the T/P switch to the center position.
5
T P
CF/DXD
Using the CF/DXD Button
Touching the CF/DXD button repeatedly cycles the system through DXD, CF,
and normal modes. The red and green lights next to the CF/DXD button will
help you recognize which mode the system is in.
Green and red light off = Normal mode
If the red light next to the CF/DXD button is flashing, notify the system
administrator who should refer to Section 7, "Troubleshooting."
To return to CF mode after an error has been corrected:
Touch CF/DXD three times.
1
The first time puts the system in normal mode; the second touch of the button puts the system
in DXD mode; the third touch puts the system in CF mode.
CF/DXD
#
password 00
T P
83
Only green light on = DXD mode
Only red light on = CF mode
Red light flashing = Problem with CF
CF/DXD
CF/DXD
tel. no. + #