Lucent Technologies MERLIN Plus Release 2 System Manual page 204

Hold Retrieve
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
If you do not have a line button for a call that you have received or that has been
transferred to you, you can still put it on hold using the Hold button. However,
to retrieve the call, you must use a dial code or program a Retrieve Call button.
To use this feature, you can either program a button or use a dial code.
This feature is especially useful for 5-Button voice terminals that may not have
line buttons for every incoming or transferred call.
If your system administrator has set your voice terminal for Button-Free Line
Operation, you should have a Hold Retrieve button on your voice terminal, so
that you can put calls on hold and retrieve them later. (See "Button-Free Line
Operation.")
None
To program a Hold Retrieve button for your voice terminal:
Label the button Retrieve Call.
1
Slide the T/P switch to P.
2
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
Touch the button you want to program.
3
Dial *95*.
4
Slide the T/P switch to the center position.
5
T P
Retrieve
Call
You can use a programmed button or a dial code to access this feature.
To put a call on hold:
Touch Hold.
1
Hold
T P
95
MERLIN Plus System Features
I
5-85