Lucent Technologies MERLIN Plus Release 2 System Manual page 21

MUSIC-ON-HOLD
BACKGROUND MUSIC
OUTSIDE TELEPHONE
LINES
2-4 System Configuration Form
If you have an optional audio system, you can connect it with an RCA-type
phonograph jack to the Music-on-Hold jack provided at the top of the Control
Unit. Then when callers are placed on hold, they hear background music while
they're waiting.
You can control the music volume or turn off the music from the
administrator/attendant console.
Under "Music-on-Hold" . . .
If you have the optional audio equipment connected to the Music-on-Hold
jack, check that volume selection you desire.
If you have an optional audio source connected to the Music-on-Hold jack and
an optional loudspeaker paging system connected to the paging jack or a CO line
jack, you can provide background music throughout your building.
You can control the background music volume either at the audio source or at
the administrator/attendant console.
Under "Background Music" . . .
If you want to adjust the volume of the background music at the
administrator/attendant console check that volume selection you desire.
Your local telephone company gives you the telephone numbers for your outside
lines. The control unit jacks where the outside lines connect to the system are
labeled alphabetically: A through D for a system with four or fewer outside lines,
and A through H for a system with five to eight outside lines.
To simplify system administration, plan to assign your outside lines to an
unbroken sequence of jacks beginning with jack A. Begin with the lines
for your local published telephone numbers. Group special line types such as
WATS lines together in the sequence, and place any personal lines at the end of
the sequence.
Under "Outside Telephone Lines" . . .
Write in the telephone number and the line type for each of your outside lines
next to the appropriate letter.
If you have an optional loudspeaker paging system that you are planning to
connect to a CO line instead of the Paging jack on the Control Unit, write
"CO Paging" under line type for the CO line you plan to use for paging.