Lucent Technologies MERLIN Plus Release 2 System Manual page 145

ADMINISTRATION
PROGRAMMING
5-26 MERLIN Plus System Features
If your responsibilities do not include system administration, skip this
information.
The system is factory-set to have the Busy Buster feature assigned to voice
terminal jack 19 on the control unit. However, you can use the following
procedure to assign the feature to any other voice terminal jack in the system,
except jack 10.
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *35.
2
Touch the Auto Intercom button or dial the intercom number of the jack to
3
which the Busy Buster feature will be assigned.
The green light goes on next to the Auto Intercom button to which the feature will be assigned.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
Make sure the BB jack is moved to the corresponding voice terminal jack
6
you've just assigned.
T P
Administer
T
Administer
This feature requires a button with lights.
To program a button on your voice terminal for the Busy Buster feature:
Label the button Busy Buster.
1
Slide the T/P switch to P.
2
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
Touch the button you want to program.
3
Dial *31 (you do not need to dial an outside number).
4
Slide the T/P switch to the center position.
5
T P
Busy
Buster
Auto
Intercom
35
P
T P
3 1