Auto Intercom - Lucent Technologies MERLIN Plus Release 2 System Manual

Auto Intercom

DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
You can use an Auto Intercom button for one-touch dialing of intercom numbers.
Program any 2-digit intercom number onto an Auto Intercom button and use the
button whenever you want to call the intercom number.
In the MERLIN Plus system, you place an intercom call with a voice
announcement. Your co-worker hears your voice through the voice terminal
speaker and can respond to you without lifting the handset. If the co-worker
does not have a BIS model voice terminal or HFAI enabled, he or she cannot
respond to you without lifting the handset.
However, if the person you are calling has activated the Voice Announcement
Disable feature, your intercom call rings rather than beeps at the person's
voice terminal.
You cannot announce an intercom call to a person active on the
voice terminal's speaker.
You cannot have both an Auto Intercom button and a Manual Signaling button
for the same person. If you try to program both, you deactivate the one that you
programmed earlier. You can use either feature to place an intercom call.
(See "Manual Signaling.")
If you program this feature onto a button with lights, the green light next to the
button goes on when the person at that intercom number uses the voice terminal
or uses the Do Not Disturb feature. When the person calls you, the green light
next to the person's Auto Intercom button flashes.
None
A button with lights is recommended but not required for the
Auto Intercom feature.
To program an Auto Intercom button for your voice terminal:
Label the button with a name and intercom number.
1
Slide the T/P switch to P.
2
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
Touch the button you want to program.
3
Dial *91 plus an intercom number.
4
Slide the T/P switch to the center position.
5
T P
John 12
T P
91 Icom no.
MERLIN Plus System Features
5-15