Lucent Technologies MERLIN Plus Release 2 System Manual page 73

PAGING GROUPS
When you filled in the "Paging Groups" columns on the System Configuration
Form, you learned the following about paging groups:
All voice terminals are automatically assigned to a single paging group,
the Page-All Group, which you cannot change.
Intercoms 10 through 19 are automatically assigned to Page Group 1;
intercoms 20 through 29 are automatically assigned to Page Group 2.
You can assign the same voice terminal to both paging groups.
If you are using a BIS-10 or a BIS-22 voice terminal, you must administer the
Group Page feature in a slightly different way.
Look at the "Paging Groups" columns on the System Configuration Form.
If you plan to keep intercoms 10 through 19 in Page Group 1 and the remaining
intercoms in Page Group 2, you don't have to do anything here. If you plan to
change the makeup of the paging groups, follow the procedure below:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *71 for Page Group 1 or *72 for Page Group 2.
2
If you have the corresponding Auto Intercom buttons, a green light goes on next to each one
that already is assigned to that paging group.
Perform one of the following procedures:
3
> Touch the appropriate Auto Intercom button(s).
The green light goes on.
> Dial a code from the Dial Code chart (located earlier in this section under
"Using the BIS-22 Voice Terminal as an Administrator Console") that
corresponds with the voice terminal.
Touch Administer.
4
The console beeps twice.
Follow steps 2 through 4 for each paging group you want to administer.
5
Continue to administer the system, or leave administration mode.
6
Basic Administration 3-17