Lucent Technologies MERLIN Plus Release 2 System Manual page 82

RINGING OPTIONS
3-26 Line Assignments for Voice Terminals
To assign lines to a voice terminal:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Perform one of the following procedures:
2
> Touch the Auto Intercom button for the voice terminal you're
administering.
A green light goes on next to the Auto Intercom button. Green lights also go on next to
the buttons of any lines already assigned to the voice terminal.
> Dial the intercom number for the voice terminal you are administering.
Green lights go on next to the buttons of any lines already assigned to the voice terminal.
Touch all the line buttons that have a green light on next to them.
3
The green light next to each line button goes off.
In the order that you want lines to appear on the voice terminal, touch all the
4
line buttons again. If you want to reserve a button(s) for feature
programming, touch that button(s) last.
The green light goes on next to the button you touch.
Touch Administer.
5
The console beeps twice.
Continue to administer the system, or leave administration mode.
6
Perform the following procedure to select the ringing option for each line
assigned to your voice terminals:
Slide the T/P switch to P.
1
Touch the line button you want to program.
2
Dial one of the codes for the type of ringing you have indicated on the
3
Line Assignments Form:
> Dial *35 for no ring (N).
The red light next to the button goes off.
> Dial *36 for delayed ring (D).
The red light next to the button flashes.
> Dial *37 for immediate ring (I).
The red light next to the button goes on steady.
Repeat steps 2 and 3 for each line button.
4
When you've finished programming, slide the T/P switch to the center
5
position.