Lucent Technologies MERLIN Plus Release 2 System Manual page 270

ADMINISTRATION
It is sometimes necessary to include a pause, stop, or switchhook flash, or to
switch from rotary to Touch-Tone signals within a dialing sequence. To do so,
the administrator must enler one or more of the following special characters into
the dialing sequence. However, if you do use the special characters in the
dialing sequence, you cannot use Recall to retry the number for you.
To program a pause, touch Hold.
To program a stop, touch Drop.
To program Touch-Tone Enable, touch Transfer.
To program a switchhook flash at the beginning of a dialing sequence, touch
Recall and then touch Hold.
If the first digit of a System Speed Dial number is the special
NOTE:
character Recall, follow it by a pause (also a special character)
when programming the dial sequence. If you need to use Recall in
other than the first digit of the dialing sequence of a System Speed
Dial number, you cannot use the Speed Dial feature.
(For more information about using special characters in a dialing
sequence, including PBX, Centrex, and Custom Calling features, see
"Special Characters.")
If a number to which the administrator assigns a System Speed Dial code
contains a "#" character, the character must be entered twice (For example,
9##123). A single "#" character ends administration of the current
Speed Dial code.
When the administrator has dialed the maximum 16 characters for a System
Speed Dial code, the system beeps twice to confirm the entry and to remind the
administrator that he or she cannot dial any more characters. If the administrator
dials less than 16 characters, the system does not beep.
The administrator should give a copy of the System Speed Dial code
assignments to each person who will be using these codes.
People can dial the codes or program a button for specific Speed Dial codes.
If your responsibilities do not include system administration, skip this
information.
Before you administer the System Speed Dial feature, refer to the System Speed
Dial Form that you have filled out.
To assign System Speed Dial codes to frequently dialed telephone numbers:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial the code (#60 through #89 or #900 through #999) that you are assigning
2
to the telephone number.
MERLIN Pius System Features
5-151