Lucent Technologies MERLIN Plus Release 2 System Manual page 86

3-30 Line Assignments for Voice Terminals
Direct Extension Dialing (DXD)
If there is an "I" entered in this row, perform the following procedure to
administer the incoming Direct Extension Dialing line(s):
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *58 for the Direct Extension Dialing incoming line group.
2
Touch the line buttons until the green lights show the assignments
3
you want.
Green light on =
Green light off =
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5
If you entered a number other than 2 in the "Ring Interval" column for
Direct Extension Dialing, follow the procedure below to change the ring
interval for incoming DXD calls:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *761 plus the number of rings (0 through 9).
2
If 0 is selected, the voice terminal will not ring, and calls will be
NOTE:
answered immediately.
Touch Administer.
3
The console beeps twice.
Continue to administer the system, or leave administration mode.
4
If you put a telephone number in the column headed "Modify Message" for
DXD, follow the procedure below:
Enter administration mode...
1
The red lights go on next to Administer and Restrict.
Dial *50.
2
Touch the line button for the line on which you want to hear the
3
modified message.
The green light goes on.
Dial the telephone number you want to include in the message.
4
For special phone numbers, such as 800 numbers, you may
NOTE:
prefer to have the recorded voice pronounce the number as
"Eight hundred" followed by the number, instead of "Eight, zero,
zero." To do this, touch Hold to enter a pause after the toll prefix
and again after the 800 area code and then again after the
exchange. For example, 1-800-555-1212 would be entered as:
line is assigned to DXD
line is not assigned to DXD
1 Hold 800 Hold 555 Hold 1212.