Lucent Technologies MERLIN Plus Release 2 System Manual page 297

PROGRAMMING
HOW TO USE
6-6 Accessory Equipment
If you want to change the order in which the system selects available lines for
5
this telephone, assign an Automatic Line Selection sequence.
While in programming mode, dial **.
a
Touch the line buttons in the order you want them to be selected.
b
When you are finished programming the basic telephone, slide the
c
T/P switch to the center position.
If you want the basic telephone not to ring on specified lines, use the Ringing
6
Options feature. While in programming mode, touch the line for which you
want to program a ringing option:
If you don't want the phone to ring, dial *35.
a
If you want the phone to ring immediately when a call comes in, dial *37.
b
Disconnect the substitute voice terminal and connect the BTMI to the same
7
voice terminal jack. Then connect the basic telephone to the BTMI.
None
A person using a basic telephone must dial the codes shown in Figure 6-1 to
access the lines the system administrator assigns to the intercom number for the
telephone.
FIGURE 6-1 Basic telephone codes for accessing lines.
884
883
882
881
880
Transfer
Conference
Drop
Hold
889
888
887
886