Lucent Technologies MERLIN Plus Release 2 System Manual page 325

SYMPTOM:
UNSUCCESSFUL
ATTEMPTS TO USE BUSY
BUSTER.
Possible Cause 2:
The Hold Disconnect Interval setting is different than the
local telephone company's central office.
Do This
Refer to "Hold Disconnect
Interval" in Section 5,
"Reference" for instructions
to change the setting to
450 milliseconds (long) or
50 milliseconds (short) for
each incoming line.
Possible Cause 1:
Busy Buster is not connected to the port that is
administered for it.
Do This
Check the location of the BB
cord and compare its jack
number with the jack number
that was administered
for BB.
Possible Cause 2:
Returning Busy Buster call is not picked up quickly.
Do This
Answer returning Busy
Buster calls promptly y when
the voice terminal alerts you,
so that the other party doesn't
get confused by the silence
and hang up
Possible Cause 3:
The Busy Buster number is in the same local exchange as the
number you're calling from.
Do This
Place the call again.
If
The Hold Disconnect
Interval is set to 450
milliseconds (long) and
callers are no longer
disconnected when placed
on hold
The Hold Disconnect
Interval is set to 50
milliseconds (short) and the
light indicating a held call no
longer flashes after the caller
hangs up
The light continues to flash
after a caller has hung up
If
The cord is plugged into a
jack other than the one
administered for BB
If
You are interrupted by other
calls while waiting for a
Busy Buster call
If
The number is busy.
Troubleshooting Procedures
Then
You've solved the problem.
You've solved the problem.
Contact your equipment
supplier for assistance.
Then
Move the BB cord to the
administered jack or
administer the jack
assignment to the current
cord location.
Then
Activate the Do Not Disturb
feature so that only transfer
return calls, which include
Busy Buster calls, will ring at
your voice terminal.
Then
Activate Busy Buster again.
7-9