Lucent Technologies MERLIN Plus Release 2 System Manual page 165

5-46 MERLIN Plus System Features
Control Unit Jack Assignment for the Call Report Feature
To specify the voice terminal jack to which the data collector and the printer will
be connected:
The system is factory-set for jack 19.
NOTE:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *82.
2
The green light goes on next to the Auto Intercom button that corresponds with the jack to
which the data collector and the printer are currently assigned.
Touch the Auto Intercom button or dial the intercom number of the jack to
3
which the data collector and printer are currently assigned.
The green light goes off next to the Auto Intercom button that corresponds with the jack to
which the data collector and printer are currently assigned.
Touch the Auto Intercom button or dial the intercom number of the jack to
which the data collector and the printer will be connected.
The green light next to hek button goes on.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
T P
Administer
Administer
Minimum Call Duration
To specify a minimum call duration other than 1 minute for call reporting:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *83.
2
Dial one digit from 0 to 9 for the number of minutes.
3
For example, to specify a minimum duration of 10 seconds, dial *830. To
specify a minimum duration of 9 minutes, dial *839.
Ten seconds is the shortest duration you can set under one minute.
NOTE:
Touch Administer.
4
The console beeps twice.
5 Leave administration mode by sliding the T/P switch to the center position.
T P
Administer
82
T P
83 0-9
Call
Icom 19
Report 29
Administer
T P