Lucent Technologies MERLIN Plus Release 2 System Manual page 176

PROGRAMMING
HOW TO USE
Assigning Lines to Voice Terminals
Before you assign lines to voice terminals in your system, refer to the Line
Assignments Form that you have filled out.
To assign lines to a voice terminal:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Touch the Auto Intercom button or dial the intercom number for the voice
2
terminal that you are administering.
A green light goes on next to the Auto Intercom button. Green lights also go on next to the
buttons of any lines already assigned to the voice terminal.
Touch all of the line buttons that have a light next to them.
3
The green light next to each line button goes off.
Touch all the line buttons again, this time in the order that you want them to
4
appear on the voice terminal. If you want to reserve a button(s) for feature
programming, touch that button(s) last.
Green lights go on next to the line buttons you touch.
Touch Administer.
5
The console beeps twice.
If you reserved a button(s) for feature programming:
6
> Touch the button(s) that you want to be used for feature programming
again.
Green light goes off next to the button you touch.
Leave administration mode by sliding the T/P switch to the center position.
7
T P
Administer
555-9876
None
The system administrator assigns lines to buttons for the whole system and for
individual voice terminals. Be sure that the lines that you have access to are
labeled on your voice terminal.
Auto
Intercom
T P
Administer
MERLIN Plus System Features
555-1234
5-57