Lucent Technologies MERLIN Plus Release 2 System Manual page 97

Administration Procedure
Assign System Speed Dial codes to telephone
numbers and account numbers.
Assigning or removing a voice terminal from a
paging group.
Set the Transfer Return Interval.
1
Enter administration mode.
2
Dial the code (#60 through #89 or #900 through #999) you are assigning to
the number.
3 Dial either:
*90 to assign the code without Restriction Override
*92 to assign the code with Restriction Override
*88 to assign the code to an account number.
4
Dial the telephone number or account number.
To designate a telephone number as private (not printed on call
NOTE:
reports), dial * before the number in step 4.
If the telephone number or account number has the maximum allowed
16 digits, the console beeps twice when you enter the sixteenth digit.
5 Touch Administer.
The console beeps twice.
6
Leave administration mode.
1 Enter administration mode.
2
Dial the code for the paging group (*71 or *72).
3
Touch the Auto Intercom button or dial the appropriate code from the dial
code chart for the phone you want to add or remove.
Green light on = telephone is assigned
Green light off = telephone is removed
Touch DROP to remove all voice terminals from a paging group.
NOTE:
4
Touch Administer.
The console beeps twice.
5 Leave administration mode.
1 Enter administration mode.
2 Dial the code for the transfer return interval you want (up to nine rings):
*2 plus the number of rings wanted (*25 = five rings).
*20 for transferred calls to not be returned.
3 Touch Administer.
The console beeps twice.
4 Leave administration mode.
Quick Reference Guide to System Administration
Do This
(continued)
3-41