Lucent Technologies MERLIN Plus Release 2 System Manual page 225

PROGRAMMING
HOW TO USE
5-106 MERLIN Plus System Features
To program an Outside Auto Dial button for your voice terminal:
Label the button with a name and/or a number.
1
Slide the T/P switch to P.
2
The voice terminal rings every 5 seconds to remind you that you are programming and that
you cannot place or receive calls.
Touch the button you want to program.
3
Dial *90 plus a telephone number or a PBX or Centrex code (if you need to
4
include a special character in the dialing sequence, use the directions above).
Slide the T/P switch to the center position.
5
T P
Home
Office
To dial an outside number with one touch:
Without touching Speakerphone or lifting your handset, touch the Outside
1
Auto Dial button for the number you want to dial.
Your voice terminal speaker goes on, and you hear dialing.
If you programmed the special character STOP in a dialing sequence, after
2
you hear the second dial tone, touch the Outside Auto Dial button again to
continue the dialing.
When you hear the other person answer, start speaking or lift your handset
3
then start speaking.
If the line is busy or if no one answers:
Touch Speakerphone or hang up to cancel the call.
1
Speaker-
p h o n e
90 tel. no.
Home
Office
T P