Lucent Technologies MERLIN Plus Release 2 System Manual page 264

Control Unit Jack Assignment for the System Feature Report
To assign a voice terminal jack on the control unit for the System Feature
Report:
The system is factory-set to have the data collector and printer
NOTE:
connected to voice terminal jack 19 for the System Feature Report
feature.
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *85.
2
Touch the Auto Intercom button or dial the intercom number of the jack to
3
which the data collector and the printer will be connected for the
Call Report feature.
The green light next to the current jack assignment goes off; the green light next to the
Auto intercom button for the jack to which the data collector and the printer will be
connected goes on.
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
T P
Administer
T
Administer
Complete System Report
To print out a system administration report and a report for every voice terminal
in your system:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *60.
2
The printer prints the reports as it receives the data from the system.
Touch Administer.
3
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
4
T P
Administer
Call
Report 29
85
P
Administer
60
MERLIN Plus System Features
T P
5-145