Lucent Technologies MERLIN Plus Release 2 System Manual page 64

3-8 Administration Preview
To make button labels for the voice terminal you plan to use as your
administrator/attendant console, do the following:
Remove the blank button labels from the voice terminal according to the
1
instructions that came with the voice terminal.
Fill in the button labels with pencil or ballpoint pen since either can be erased
2
if you make changes later.
For any BIS-34 and 34-button voice terminals, follow the button labeling
>
shown in Figure 3-2.
> For any BIS-22 voice terminal, follow the button labeling shown in
Figure 3-3.
On the button labels divided by a horizontal line, the term above the
NOTE:
line identifies the button's function when the console is in the
normal call-handling mode. The term below the line identifies the
button's function in administration mode.
Reinsert the labels following the instructions that came with the
3
voice terminal.
Entering Administration Mode
You have to enter administration mode to set up the system initially and any time
you use the attendant console to administer the system. Follow the boxed
instructions below whenever you have to enter administration mode.
To enter administration mode:
Slide the T/P switch on the left side of the console to P (down).
1
The green lights next to the line buttons begin flashing.
The console rings every 5 seconds to remind you that it's in programming mode.
Touch Administer, or dial #49.
2
The green lights go off.
The red lights go on next to Administer and Restrict.
P
T
Administer
Entering Administration Mode