Lucent Technologies MERLIN Plus Release 2 System Manual page 87

Repeat the procedure for each line you are administering.
5
Touch Administer.
6
Continue to administer the system, or leave administration mode.
7
Remote Line Access (RLA)
If there is an "I" entered in this row, perform the following procedure to
administer the incoming Remote Line Access line group:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *54 for the Remote Line Access incoming line group.
2
Touch the line buttons until the green lights show the assignments you
3
want.
Green light on =
Green light off =
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5
If you entered a number other than 2 in the "Ring Interval" column for RLA,
follow the procedure below to change the ring interval for
incoming RLA calls:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *763 plus the number of rings (0 through 9).
2
If 0 is selected, the voice terminal will not ring, and calls will be
NOTE:
answered immediately.
Touch Administer.
3
The console beeps twice.
Continue to administer the system, or leave administration mode.
4
To use RLA, you must assign a 5-digit password (the first two digits are the
caller's intercom number) to gain access to the system from a remote
location. You also need this password when changing the call forwarding
destination number when off-site.
To assign the password, follow this procedure:
Enter administration mode.
1
The red lights go on next to Administer and Restrict
To create a password for a particular intercom number, dial the intercom
2
number plus any three digits except 000.
Touch Administer.
3
The console beeps twice.
Continue to administer the system, or leave administration mode.
4
line is assigned to RLA
line is not assigned to RLA
Line Assignments for Voice Terminals
3-31