Lucent Technologies MERLIN Plus Release 2 System Manual page 237

5-118 MERLIN Plus System Features
Perform one of the following procedures:
3
> Touch the Auto Intercom button of the voice terminal that you are
administering.
Green light on = the voice terminal is locked.
Green light off = programming can be done from the voice terminal.
> If You don't have an Auto Intercom button for the voice terminal, then use
the corresponding dial code from the chart below:
If the intercom
number is:
Intercom 10
Intercom 11
Intercom 12
Intercom 13
Intercom 14
Intercom 15
Intercom 16
Intercom 17
Intercom 18
Intercom 19
Touch Administer.
4
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
5
T P
Administer
T
Administer
If you want to lock the programming function on all the voice terminals in your
system (except the administrator/attendant console connected to jack 10):
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *89.
2
Perform one of the following procedures according to whether you want to
3
lock or unlock the programming function at all the voice terminals in
your system:
> Touch Conference to lock every voice terminal in your system.
A green light goes on next to the Auto Intercom button corresponding to the appropriate
voice terminals. The voice terminals are locked; they cannot enter programming mode.
> Touch Drop to unlock all voice terminals in your system.
A green light goes off next to the Auto Intercom button corresponding to the appropriate
voice terminals. The voice terminals are unlocked; they can enter programming mode
when necessary.
If the intercom
Dial this code: number is:
#22 Intercom 20
#21 Intercom 21
#20 Intercom 22
#19 Intercom 23
#18 intercom 24
#17 Intercom 25
#16 Intercom 26
#15 Intercom 27
#14 Intercom 28
#13
Intercom 29
Auto
Intercom
89
P
Dial this code:
#03
#04
#05
#06
#07
#08
#09
#10
#11
#12