Lucent Technologies MERLIN Plus Release 2 System Manual page 84

LINE ASSIGNMENTS FOR
ASA FEATURES
3-28 Line Assignments for Voice Terminals
The four Automatic System Access (ASA) features require the assignment of
incoming lines and one requires the additional assignment of outgoing lines.
Call Forwarding (CF)
If there is an "I" and an "O" entered under two lines in this row, perform the
following procedure to administer the incoming and outgoing
call forwarding lines:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial the code for the type of line group you want to administer
2
> Dial *51 for a Call Forwarding incoming line group.
> Dial *52 for a Call Forwarding outgoing line group.
Touch the line buttons until the green lights show the assignments you want
3
to each line group.
Green light on =
Green light off =
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5
If you entered a number other than 2 in the "Ring Interval" column for call
forwarding, follow the procedure below to change the ring interval for
incoming CF calls:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *762 plus the number of rings (0 through 9).
2
If 0 is selected, the voice terminal will not ring, and calls will be
NOTE:
forwarded immediately.
Touch Administer.
3
The console beeps twice.
Continue to administer the system, or leave administration mode.
4
If you put a telephone number in the column headed "Modify Message" for
Call Forwarding, follow the procedure below:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *50.
2
Touch the line button for the line on which you want to hear the
3
modified message.
The green !ight goes on.
line is assigned to the group
line is not assigned to the group