Lucent Technologies MERLIN Plus Release 2 System Manual page 278

Touch-Tone or Rotary Setting
DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
HOW TO USE
When the MERLIN Plus system is installed, it is set to generate Touch-Tone
signals. If any of the system's lines are rotary, the administrator must reset the
system to rotary dialing by entering a code at the administrator/attendant
console.
If your system has any rotary lines, you should select the rotary setting for the
system then program a Touch-Tone Enable button which can be activated when
you are using your Touch-Tone lines. (See "Touch-Tone Enable".)
If your responsibilities do not include system administration, skip this
information.
To set your system for rotary dialing:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *39.
2
Touch Administer.
3
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
4
T P
Administer
If you need to reset the system for Touch-Tone dialing:
Enter administration mode by sliding the T/P switch to P and touching
1
Administer.
Dial *38.
2
Touch Administer.
3
The console beeps twice.
Leave administration mode by sliding the T/P switch to the center position.
4
T P
Administer
None
If you have telephone lines that carry rotary signals, you can switch to
Touch-Tone signals midway through a dialing sequence by using the
Touch-Tone Enable feature. (See "Touch-Tone Enable.")
Administer
39
Administer
38
MERLIN Plus System Features
T P
T P
5-159