Personal Speed Dial - Lucent Technologies MERLIN Plus Release 2 System Manual

Personal Speed Dial

DESCRIPTION
CONSIDERATIONS
ADMINISTRATION
PROGRAMMING
If you don't have many available buttons on which to program Outside Auto
Dial, you can use the programming instructions below to assign a 3-character
Personal Speed Dial code (from #01 through #24 for BIS-10 models and from
#01 through #12 for BIS-22 models) to telephone numbers, PBX, Centrex,
or Custom Calling feature codes you frequently dial.
You can assign a Personal Speed Dial code to a sequence containing up to 16
numbers and special characters.
Personal Speed Dial uses a dialing code. You do not place these codes on a
voice terminal button.
None
This feature is not associated with a voice terminal button.
Programming a Pause, Stop, or Switchhook Flash
You may need to program a pause, stop, or switchhook flash into a Personal
Speed Dial sequence, or you may need to switch from rotary to Touch-Tone
signals in the middle of a programmed dialing sequence. To do so, you must
enter one or more of the following special characters when you program the
sequence. (For more information about using special characters in a dialing
sequence, see "Special Characters in Dialing Sequences.")
To program a pause, touch Hold.
To program a stop, touch Drop.
To program a switchhook flash at the beginning of a number, touch Recall
and then touch Hold.
To program Touch-Tone Enable into a dialing sequence, touch Transfer.
MERLIN Plus System Features
5-109