Lucent Technologies MERLIN Plus Release 2 System Manual page 72

3-16 Basic Administration
Changing the Reports jack assignment for System Feature Report:
If you are using the same printer and data collector for producing
NOTE:
Call Reports and System Feature Reports, you must administer the new
jack assignment for both features.
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *85.
2
The green light goes on next to the Auto Intercom button of the jack assigned to System
Feature Report.
Perform one of the following procedure:
3
> Touch the Auto Intercom button of the jack you want to assign to System
Feature Report.
The green light goes off next to the old Auto Intercom button, and the green light goes on
next to the newly assigned Auto Intercom button.
> Dial the intercom number of jack you're assigning to
System Feature Report.
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5
Assigning an Alternate Attendant position:
Enter administration mode.
1
The red lights go on next to Administer and Restrict.
Dial *79.
2
Perform one of the following procedures:
3
> Touch the Auto Intercom button of the voice terminal you want to assign
as the Alternate Attendant position.
> Dial the intercom number of voice terminal you're assigning for the
Alternate Attendant.
Touch Administer.
4
The console beeps twice.
Continue to administer the system, or leave administration mode.
5