Lucent Technologies MERLIN LEGEND Release 6.1 Feature Reference page 676

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Features
Speed Dial
Mode Differences
Hybrid/PBX Mode
A pool dial-out code or an Idle Line Preference access code can be included with
the telephone number in a Personal Speed Dial or System Speed Dial code. To
allow time to receive a local telephone company dial tone, Pause characters may
be required immediately following either a pool dial-out code or an access code
for a long-distance carrier. Pauses are not needed following the ARS code.
When ARS is used, the pound sign ( ) should be pressed twice after the dialed
digits during programming of a Personal Speed Dial or System Speed Dial code
for a 7-digit toll number. This signals the end of the dialing sequence. See
Appendix H, "Programming Special Characters," for information about special
characters.
Behind Switch Mode
The user can program into Personal Speed Dial or System Speed Dial codes any
dial-out codes required by the host system.
To allow time to receive a telephone company dial tone, Pause characters may be
programmed after a pool dial-out code. Pause characters may also be required by
the host system or after entering an access code for a long-distance carrier.
Telephone Differences
Direct-Line Consoles
System Speed Dial numbers can be programmed from the first DLC connected to
the first analog extension jack. In extension programming, press the Feature
button or pound sign ( ), the 3-digit System Speed Dial code, the outside
telephone number, and the pound sign.
Queued Call Consoles
Personal Speed Dial and System Speed Dial cannot be used to dial numbers on a
QCC. Directory features can be used instead.
Other Multiline Telephones
System Speed Dial
To dial a System Speed Dial number, press a System Speed Dial button
programmed with the code. Alternatively, lift the handset, press the Feature
button, and dial the System Speed Dial code associated with the number. Analog
multiline telephone users without programmed Feature buttons should select an
SA or ICOM button, lift the handset, and dial the System Speed Dial code.
4 2
4 2
4 2
4 2
4 2
4 2
4 2
Issue 1
August 1998
Page 627
4 2