Lucent Technologies MERLIN LEGEND Release 6.1 Feature Reference page 357

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Features
Forward and Follow Me
Display
continued
Do Not Disturb
Group Calling
HotLine
Multi-Function
Module
When an MLX display telephone user turns Follow Me on or off, the
display prompts for the forwarding extension. After the feature is
activated, the message
deactivated, one of two messages appears:
if you deactivated the feature for one extension
if you deactivated the feature for all extensions.
If an MLX display telephone user enters an invalid destination while
turning on Forward, the display clears. If a user enters an invalid
extension while turning on Forward, Remote Call Forwarding, or
Follow Me at an analog multiline display telephone,
Calls are not forwarded to a destination extension that has Do Not Disturb
turned on; the call rings only at the forwarding telephone as described in
Table 22, page 297. Turning on Do Not Disturb at the forwarding
extension does not prevent calls from being forwarded.
In Release 4.0 and later systems, turning on Do Not Disturb at a
forwarding extension causes calls to be forwarded immediately. The
Forwarding Delay has no effect.
In Release 6.0 and later systems (Hybrid/PBX mode only), calls
forwarded to an extension on a remote system that has activated Do Not
Disturb receive a busy tone or follow the coverage programmed for that
extension.
An available calling group member is automatically logged out when the
member forwards his or her calls. If a calling group member logs in while
calls are being forwarded, Forward or any type of Remote Call
Forwarding is automatically canceled.
Calls cannot be forwarded to a calling group.
When a line/trunk programmed to ring into a calling group is assigned as
a personal line on a principal user's telephone, an incoming call received
on the personal line is not sent to the calling group if the principal user
forwards calls to an outside telephone number through Remote Call
Forwarding or Centrex Transfer via Remote Call Forwarding.
Forward and Follow Me are not intended for HotLine extensions (Release
5.0 and later systems) but can be used at these extensions. Forwarding
must be programmed at the extension before it is assigned as a HotLine
extension. Follow Me cannot be activated at a HotLine extension.
To cancel both Forward and Follow Me at a Hotline extension, you must
use a telephone at a non-HotLine extension.
Remote Call Forwarding is not intended for HotLine extensions but can
be programmed before the extension is assigned as a HotLine. To cancel
Remote Call Forwarding, remove HotLine programming first.
Forward (including Remote Call Forwarding) and Follow Me should not
be used on an MFM because the user does not have an LED that
indicates when the feature is active.
appears. After the feature is
Issue 1
August 1998
Page 308
is displayed.