Lucent Technologies MERLIN LEGEND Release 6.1 Feature Reference page 279

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Features
Direct Station Selector
Operator park zone codes must be included in the extension number range
specified for one of the Page buttons.
If a local extension is busy because features are being assigned through system
or centralized telephone programming, the red LED next to the associated DSS
button is on to indicate the busy condition.
When a QCC is active on a call, a press of a DSS button for a line/trunk number,
LDN, or unassigned extension number is ignored.
In Release 6.1 and later systems, a call to a non-local dial plan extension, using a
DSS button at a QCC, will be automatically transferred if the extended call
completion option at the QCC is programmed for Automatic Completion. If the
QCC is not programmed for Automatic Completion, hangup or depression of the
Release button completes the transfer. In both of the above situations the call will
be callback queued if no facilities associated with the route are available. Local
dial plan extension transferring is not changed.
!
SECURITYlALERT:
Do not include the ARS access code in the non-local dial plan.
In Release 2.1 and later systems, when a call is forwarded to a multiline telephone
that has a DSS button for the forwarding telephone, the light next to the DSS
button does not flash.
DSSs that are out of the building require additional local power. Any console with
two DSSs requires local power.
Mode Differences
Behind Switch Mode
In Behind Switch mode, DSS buttons for operator park zones do not work.
Feature Interactions
Automatic Route
Selection
Barge-In
The LED next to a DSS button for the ARS code is always off. For the
local system only, if the local ARS access code programmed on a DSS
button is pressed, the call is set up and always requires the remaining
called digits to be entered manually and the transfer to be completed
manually, pressing the Release button or hanging up.
After making a call to an extension by using a DSS button on a DLC,
activate Barge-In by pressing a programmed Barge-In button. QCC
operators select the feature from the display.
1 7
Issue 1
August 1998
Page 230