Lucent Technologies MERLIN LEGEND Release 6.1 Feature Reference page 578

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Features
Primary Rate Interface (PRI) and T1
Callback
Camp-On
Conference
Coverage
Calling Restrictions
Forward and
Follow Me
Group Calling
HFAI
Hold
Music On Hold
Night Service
Paging
Callback cannot be used to request a busy PRI line assigned as a
personal line, but PRI lines in a pool are eligible for Callback. An idle PRI
line is not considered an available pool member unless a check
determines that it is associated with an available B-channel. Even if a
B-channel is available when the pool selects a line for a callback call,
there may be none available when it is time to send a setup message to
the network. Or, after the setup message is sent, the network may
determine that the B-channel proposed by the system is not available. In
either case, the call fails and a fast busy tone is applied.
Some applications (such as desktop video systems) that use data lines
may work improperly when releasing data facilities requested by
Callback.
The system does not support Camp-On onto data calls.
The system does not support conferencing onto data calls.
Data calls do not follow coverage delay settings. All data calls ring
immediately.
Outward and toll restrictions do not work with T1 lines emulating tie trunks
when the lines are set to Tie-PBX or Tie Switched 56 Data. Use Automatic
Route Selection or pool dial-out codes instead.
A PRI line that has been programmed for routing by dial plan cannot have
Remote Call Forwarding allowed. A T1 Switched 56 line cannot be used
for Remote Call Forwarding.
A PRI line that is a member of a B-channel group programmed for routing
by dial plan should not belong to a calling group. A line that is part of a
B-channel group included in a calling group should not be programmed
for routing by dial plan.
Incoming calls on a line that is a member of a B-channel group
programmed for routing by dial plan are not eligible for answer by
Hands-Free Answer on Intercom.
Data calls cannot be placed on hold.
Music on Hold cannot be used with data calls.
A PRI B-channel can be assigned to a Night Service group (Release 4.1
and later systems only) if its B-channel group has been programmed for
routing by line appearance. If the Routing by Dial Plan option has been
selected for a PRI B-channel group, its lines cannot be assigned to a
Night Service group.
If the extension for an incoming call matches a group paging extension,
the call is treated as an unassigned DID call.
Data lines cannot be used for paging.
Issue 1
August 1998
Page 529