Lucent Technologies MERLIN LEGEND Release 6.1 Feature Reference page 260
Release 6.1
Hide thumbs
Also See for MERLIN LEGEND Release 6.1:
- System programming manual (1010 pages) ,
- System planning manual (588 pages) ,
- Maintenance and troubleshooting manual (510 pages)
Table of Contents
Advertisement
MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Features
Direct-Line Console
Mode Differences
Hybrid/PBX Mode
If QCCs are assigned with DLCs, a QCC must be connected to the first extension
jack on the first MLX module in the first carrier as the primary system operator
position.
Pool buttons cannot be assigned on a DLC; however, lines/trunks included in a
pool can be assigned as personal line buttons on a DLC. In Release 6.0 and later
systems (Hybrid/PBX mode only), private trunks must not be assigned as
personal lines on a DLC.
Lines that are not assigned to buttons on the DLC can be selected by the operator
only by dialing the pool dial-out code from the SA button or, on an MLX DLC, by
selecting a DSS button for the pool dial-out code. In Release 6.0 and later
systems (Hybrid/PBX mode only), a DLC should not be given dial access to
private trunk pools.
Lines that are not assigned to a pool cannot be selected from a DLC unless they
are assigned to buttons on the console. Shared SA buttons cannot be assigned to
DLCs.
Key and Behind Switch Modes
Only DLCs (not QCCs) are allowed in Key and Behind Switch modes.
A DLC operator cannot select lines that are not assigned to buttons on the
console.
Telephone Differences
MLX Telephones
An MLX-20L assigned as a DLC can also be used for system programming by
connecting it to any of the first five extension jacks on the first MLX module and
designating the extension jack for system programming. The Home screens of the
MLX-20L and MLX-28D are the same as those of non-operator telephones.
The built-in DSS field on the MERLIN II System Display Console corresponds to
physical extension jacks in the control unit, instead of specific extension numbers
in the numbering plan. Therefore, DSS buttons on the MERLIN II System Display
Console cannot be used to monitor the busy status of pools or calling groups or to
place or transfer calls to a non-local extension.
Issue 1
August 1998
Page 211
Advertisement
Table of Contents
