console(config-rtr)#external-lsdb-limit 100
ipv6 ospf
Use the ipv6 ospf command in Interface Configuration mode to enable
OSPF on a router interface or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF on VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf
ipv6 ospf areaid
Use the ipv6 ospf areaid command in Interface Configuration mode to set
the OSPF area to which the specified router interface belongs.
Syntax
areaid
ipv6 ospf areaid
areaid
no ipv6 ospf areaid
952
OSPFv3 Commands