Delta MS300 Series User Manual page 141

Chapter 7 Optional AccessoriesMS300
16. Start Wizard
16.1 New drive start-up setting process
When a new drive is powered on, it directly enters the Start Wizard. There are three modes in
the start-up setting process: Start Wizard, Exit Wizard and Test Mode.
(1) Start Wizard:
 In Start Wizard, you can set drive's parameters such as Calendar, Maximum operation
frequency and Maximum voltage...; refer to Table 1 for setting items and orders.
 The drive exits Start Wizard when you finish the complete setting process, and will not
enter this process when rebooting the power.
(2) Exit Wizard:
 Exit the Start Wizard mode. The drive does not go to Start Wizard when rebooting the
power.
(3) Test Mode:
 This function is hidden to avoid misuse. Refer to the following flow chart to enter Test
Mode.
 When the drive is in Test mode, it temporarily disables the Start Wizard and Exit Wizard
mode.
 The Test Mode is designed for distributors / suppliers / clients to manage and operate
the drive before shipping it out.
If you enter Test Mode without exiting the Start Wizard process, the drive will begin with

the new drive start-up process upon next power on.
Setting
Order
1 Calendar
2 Output frequency of motor 1
3 Output voltage of motor 1
4 Full-load current for induction motor 1 (A)
5 Number of poles for induction motor 1
6 Rated speed for induction motor 1 (rpm)
7 Minimum output frequency of motor 1
8 Maximum operation frequency
Master frequency command source (AUTO) / Source
9
selection of the PID target
10 Operation command source (AUTO)
11 V/F curve selection
12 Acceleration time 1
13 Deceleration time 1
Table 1. Start Wizard setting items
Description
132
Parameter
N/A
01-01
01-02
05-01
05-04
05-03
01-07
01-00
00-20
00-21
01-43
01-12
01-13