Delta MS300 Series User Manual page 430

09-76
Communication Card IP Address 1 (for EtherNet)

09-77
Communication Card IP Address 2 (for EtherNet)

09-78
Communication Card IP Address 3 (for EtherNet)

09-79
Communication Card IP Address 4 (for EtherNet)

Settings
 Use Pr.09-76–Pr.09-79 with a communication card.
09-80
Communication Card Address Mask 1 (for EtherNet)

09-81
Communication Card Address Mask 2 (for EtherNet)

09-82
Communication Card Address Mask 3 (for EtherNet)

09-83
Communication Card Address Mask 4 (for EtherNet)

Settings
09-84
Communication Card Gateway Address 1 (for EtherNet)

09-85
Communication Card Gateway Address 2 (for EtherNet)

09-86
Communication Card Gateway Address 3 (for EtherNet)

09-87
Communication Card Gateway Address 4 (for EtherNet)

Settings
09-88
Communication Card Password (Low Word) (for EtherNet)

09-89
Communication Card Password (High Word) (for EtherNet)

Settings
09-90
Reset Communication Card (for EtherNet)

Settings
09-91
Additional Settings for the Communication Card (for EtherNet)

Settings
0–255
0–255
0–255
0–99
0: Disable
1: Reset to defaults
bit 0: Enable IP filter
bit 1: Enable Internet parameters (1 bit)
When the IP address is set, this bit is enabled. After updating the
parameters for the communication card, this bit changes to disabled.
bit 2: Enable login password (1 bit)
When you enter the login password, this bit is enabled. After updating
the communication card parameters, this bit changes to disabled.
Chapter 12 Descriptions of Parameter SettingsMS300
421
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0
Default: 0