Delta MS300 Series User Manual page 245

Chapter 11 Summary of Parameter SettingsMS300
Pr. Explanation
06-23 Fault Output Option 1

06-24 Fault Output Option 2

06-25 Fault Output Option 3

06-26 Fault Output Option 4

Electronic Thermal Relay
06-27

Selection 2 (Motor 2)
Electronic Thermal Relay
06-28

Action Time 2 (Motor 2)
06-29 PTC Detection Selection

81: W-phase Over-current before run (coc)
82: Output phase loss U phase (oPL1)
83: Output phase loss V phase (oPL2)
84: Output phase loss W phase (oPL3)
87: Low frequency overload protection (oL3)
89: Rotor position detection error (roPd)
101: CANopen guarding error (CGdE)
102: CANopen heartbeat error (CHbE)
104: CANopen bus off error (CbFE)
105: CANopen index error (CidE)
106: CANopen station address error (CAdE)
107: CANopen index setting exceed limit (CFrE)
121: Internal communication error (CP20)
123: Internal communication error (CP22)
124: Internal communication error (CP30)
126: Internal communication error (CP32)
127: Internal communication error (CP33)
128: Over-torque 3 (ot3)
129: Over-torque 4 (ot4)
134: Internal communication error (EoL3)
135: Internal communication error (EoL4)
140: oc hardware error (Hd6)
141: GFF occurs before run (b4GFF)
142: Auto-tune error 1 (AuE1)
143: Auto-tune error 2 (AuE2)
144: Auto-tune error 3 (AuE3)
149: Auto-tune error 5 (AuE5)
0–65535 (refer to bit table for fault code)
0–65535 (refer to bit table for fault code)
0–65535 (refer to bit table for fault code)
0–65535 (refer to bit table for fault code)
0: Inverter motor (with external forced cooling)
1: Standard motor (motor with fan on the shaft)
2: Disabled
30.0–600.0 sec.
0: Warn and continue operation
1: Fault and ramp to stop
2: Fault and coast to stop
3: No warning
236
Settings Default
0
0
0
0
2
60.0
0